4 x blackened stainless steel screws for wheel arch liner. 4 x blackened stainless steel washers for wheel arch liner.4 x Spire Clip for wheel arch liner edge (Original MGR). The inner mounting to body bolt screws into a captive nut in the bodywork, this bolt often shears off. The kit provides an extra flange nut to replace the captive nut- see photos.
The two screws from each wheel arch to bumper are prone to corrosion making them difficult to remove and are visible items which can look unsightly. They are not identified on the EPC (Electronic Parts Catalogue) and are mild steel SEMS screws (screw with pre-asSEMbled washer) originally finished in a matt black "Geomet" coating.
The screws and washers supplied in the kit have the same dimensions and are high quality stainless steel that have been blackened with a black oxide process to give the original factory appearance. The plastic scrivets (screw - rivets) can be difficult to remove and often round off, needing to be prized out which damages them. The plastic wheel arch liners need to be pulled rearwards to gain access for changing the front subframe mountings. Austingarages is a specialist MG Rover garage and our kits are created from years of workshop experience and the drive to put Quality First.
This item is in the category "Vehicle Parts & Accessories\Car Parts & Accessories\Exterior Parts & Accessories\Frame Rails & Subframes". The seller is "austingarages" and is located in this country: GB. This item can be shipped to United Kingdom.